TERMIUM Plus®

La banque de données terminologiques et linguistiques du gouvernement du Canada.

TEST PELLE [1 fiche]

Fiche 1 2009-01-30

Anglais

Subject field(s)
  • Atmospheric, Climatic and Meteorological Phenomena
CONT

The shovel shear test provides information about the location where the snow could fail in shear. It is best applied for identification of buried weak layers and does not usually produce useful results in layers close to the snow surface. Soft snow near the surface is better tested with the tilt board and the shear frame or an improvised version of this tilt test.

CONT

Shovel Shear Test. This test can be done on a flat or on a slope. With good technique, the location of weak layers, even thin weak layers, can be found. First dig a hole or pit in the snow. The vertical wall of the pit should be straight up and down, and smooth. Make a mark on the uphill portion of one corner of your pit with your shovel blade. This will mark the boundaries of your column, which should be roughly 30 cm by 30 cm or 12 inches square. (A) Now, cut both sides using a snow saw or your ski, all the way to the floor of the pit making sure that the cuts are straight. (B) The back of the column should only be cut as deep as your shovel blade is long, so measure with your shovel blade (C) and then cut the back. (D) Next, insert your shovel, blade down, in the back cut of the column and pull gently and evenly forward being careful not to lever your shovel handle. (E) Examine the shear layer where the block failed. (F) The force applied to the shovel that causes a weak layer to shear from the layers surrounding it can be rated as follows: Very easy ... Easy ... Moderate ... Hard ...

CONT

The results of the shovel shear test were inconclusive. [Example approved by the Avalanche Bulletin Terminology Standardization Committee.]

OBS

Shovel test: abbreviated form of "shovel shear test." Shovel test may also refer to the shovel tilt test or the shovel compression test.

OBS

Observers are cautioned that identification of the weak layers is the primary objective of the shovel shear test. The shovel shear test is not a stability test.

OBS

shovel shear test: term officially approved by the Avalanche Bulletin Terminology Standardization Committee.

Français

Domaine(s)
  • Phénomènes météorologiques, climatiques et atmosphériques
CONT

Le test de la pelle consiste à isoler une tranche du manteau neigeux de base carrée (la largeur est celle de la pelle, soit une trentaine de centimètres en moyenne), puis à la tirer vers soi ou à la charger pour détecter la présence de plan(s) de glissement potentiel(s).

CONT

Le test de cisaillement à la pelle n'a pas donné de résultats définitifs. [Exemple entériné par le Comité d'uniformisation de la terminologie des bulletins d'avalanche.]

OBS

[Ce test n'est] pas à proprement parler un test de stabilité.

OBS

Test de la pelle. [...] Il existe plusieurs variantes de ce test sous la même désignation. Méthode Faarlund. [...] Méthode de Munter.

OBS

test de cisaillement à la pelle; essai de cisaillement à la pelle : termes uniformisés par le Comité d'uniformisation de la terminologie des bulletins d'avalanche.

Espagnol

Conserver la fiche 1

Avis de droit d’auteur pour la banque de données TERMIUM Plus®

© Services publics et Approvisionnement Canada, 2024
TERMIUM Plus®, la banque de données terminologiques et linguistiques du gouvernement du Canada
Un produit du Bureau de la traduction

En vedette

Portail linguistique du Canada

Accédez à une collection de ressources canadiennes sur tous les aspects du français et de l'anglais, y compris des jeux.

Outils d'aide à la rédaction

Les outils d’aide à la rédaction du Portail linguistique ont fait peau neuve! Faciles à consulter, ils vous donnent accès à une foule de renseignements utiles pour mieux écrire en français et en anglais.

Lexiques et vocabulaires

Accédez aux lexiques et vocabulaires du Bureau de la traduction.

Date de modification :