TERMIUM Plus^®

Fiche 1,  Justifications,  Anglais

Record number: 1, Textual support number: 1 CONT

After closing and sealing the door, setting the timer, and pulling out the operating handle, the steam inlet valve from the boiler opens, allowing steam at a pressure of 6 psi to enter the compartment. Air from the sealed compartment exits through the vent until the temperature reaches 180°F; then the vent closes and the compartment can become pressurized.  3, fiche 1, Anglais, - steam%20inlet%20valve

Fiche 1,  Justifications,  Français

Record number: 1, Textual support number: 1 CONT

Une fois le temps de cuisson écoulé, interrompre l'admission de vapeur progressivement en ramenant lentement la manette en position première; ceci a pour effet de fermer le robinet d'admission de vapeur et d'ouvrir le robinet de purge ou de vidange.  1, fiche 1, Français, - robinet%20d%27admission%20de%20vapeur

Fiche 1,  Justifications,  Espagnol

Fiche 2,  Justifications,  Anglais

Record number: 2, Textual support number: 1 CONT

A floating flame is an indication that there is a lack of secondary air to the flame. In severe cases, the flame will leave the burner and have the appearance of a floating cloud. Again, the intermediate products of combustion are apt to escape from place to place wherever sufficient air for combustion may be found. This flame is sometimes hard to detect because, as the door to the equipment is opened sufficient air will be admitted to allow the flame to rest on the burner properly. However, the obnoxious odor of aldehydes may still be detected. Another possible cause of this flame is an improperly operating vent system. If the products of combustion cannot escape, fresh air cannot reach the flame  1, fiche 2, Anglais, - floating%20flame

Record number: 2, Textual support number: 2 CONT

When a flame raises off the burner it is important to determine if it is a "lifting flame" or a "floating flame": "Lifting Flames" rise from the ports to burn some distance above the ports. In some cases these flames will drop back to the port and lift again intermittently. They are caused by too much primary air. Decreasing the shutter opening will stop lifting flames. "Floating Flames" are long and lazy looking, poorly defined, quiet flames which roll around the combustion chamber sometimes completely off the ports. Floating flames result from too little secondary or "make up" air. Lack of secondary air can be caused by incorrect venting, clogged flueways, blocked secondary air inlet openings, or lack of natural room makeup air to the oven.  2, fiche 2, Anglais, - floating%20flame

Fiche 2,  Justifications,  Français

Fiche 2,  Justifications,  Espagnol

Fiche 3,  Justifications,  Anglais

Record number: 3, Textual support number: 1 CONT

Retorts are generally large vessels into which a product is placed for processing or cooking with relatively low pressure steam. An example would be a canning retort into which sealed tins of food are placed. Steam is then used to heat or cook the contents of the can. Once the door is closed, it is vital to ensure that all the air and condensate is removed and replaced by dry saturated steam. A float-thermostatic trap(with its inbuilt air vent) is ideal, especially due to its ability to pass large volumes of condensate at relatively low pressure...  1, fiche 3, Anglais, - canning%20retort

Fiche 3,  Justifications,  Français

Fiche 3,  Justifications,  Espagnol

Fiche 4,  Justifications,  Anglais

Record number: 4, Textual support number: 1 CONT

With conventional gas furnaces, little can be done to prevent losses of heated house air up the chimney when the furnace is firing. What can be prevented, though, is the loss that occurs when the furnace is not firing. A positive vent damper consists of a tight-fitting hinged damper door mounted in a steel collar and fitted into the flue pipe just before the pipe enters the chimney base. A fail-safe interlock switch prevents the furnace from firing unless the damper is completely open. This device may also be used with propane furnace.  1, fiche 4, Anglais, - positive%20vent%20damper

Fiche 4,  Justifications,  Français

Fiche 4,  Justifications,  Espagnol

Fiche 5,  Justifications,  Anglais

Record number: 5, Textual support number: 1 OBS

perform following steps to remove ac motor-driven hydraulic reciprocating pump assembly(ac hydraulic pump) :(...) Open hydraulic access door F321 and depress vent valve(reservoir air bleed valve) above reservoir No. 2.  1, fiche 5, Anglais, - hydraulic%20access%20door

Fiche 5,  Justifications,  Français

Fiche 5,  Justifications,  Espagnol